Device Data

Every symbol instance on a sheet hangs from a 设备 (device) record. Device records are the single source of truth shared by the BOM, the terminal schedule, and cross-references: a device's coil, its contacts, and any number of scattered symbols all share one tag and one set of model information.

Device data fields

Select a component and you can edit seven fields in the 设备信息 (Device Data) section of the inspector:

FieldPurpose
代号 (Tag)The item reference, e.g. QM1, KM1, KA3. The BOM and cross-references group by it, and it should be unique across the project.
名称 (Name)Device name, e.g. “交流接触器” (_AC contactor_).
型号 (Model)Ordering model number, e.g. LC1D09.
规格 (Rating)Key ratings, e.g. 9A 220V AC.
物料编码 (Material code)Your company's internal part code; exported as its own column in the BOM.
制造商 (Manufacturer)Brand / maker.
备注 (Notes)Free text, ending up in the BOM's notes column.

Automatic tag generation

When you place a component, EletraDraw takes the letter prefix of the symbol code and appends the highest existing sequence number of that kind on the current page/project plus one — so the second AC contactor becomes KM2. Terminals (XT), earth (PE), and interruption points do not participate in the automatic tag sequence. The generated value is only a starting point: you can rewrite the Tag at any time to match your company's conventions, such as -KM1 or 3KM1.

If two devices use the same tag, the Electrical Check reports “设备代号「KM1」重复出现 2 次” (_device tag “KM1” appears 2 times_), and in the Pro version the canvas also marks the affected components with a red !.

Linking to one device

A real-world part often appears several times on a drawing: the coil in the main circuit, several auxiliary contact groups, multi-contact symbols from the library. Point them all at the same device record:

  1. Select the scattered symbol (say, a normally-open contact) and open the 关联到已有设备 (Link to Existing Device) drop-down in Device Data.
  2. The list shows the other devices in the form “KM1 · 交流接触器”; picking one completes the link. When the project contains only one device it shows 暂无其他设备 (No other devices yet).
  3. After linking, editing these fields is synchronized: change the Model on any symbol and every symbol of the same device updates. In the undo list the corresponding action names are 关联设备 (_Link Device_) and 修改设备属性 (_Modify Device Attributes_).

Tip

There is no “unlink” button. The interface only offers “Link to Existing Device”. To separate a symbol from its device, simply change its Tag to a new, unused value; two symbols written with the same tag are the same device.

What linking gives you

The “端子” (Terminal) section at the top of the inspector — present only for terminal-type symbols — offers three fields: 端子排 (Terminal Rail), 端子号 (Terminal Number), and 备注 (Notes). They write back into the device record and become columns of the terminal schedule directly; see Terminal Schedule for details.

← Back to the website